ARMOR 3 Vehicle Installation

T

Introduction

Welcome to the ARMOR 3 Two-Wire Vehicle Installation Guide. In this knowledge base article, Keith Bunch will guide you through the steps for installing your ARMOR 3 device using the 2-wire harness included in your kit. This guide is designed to ensure a smooth installation process and get your ARMOR 3 device up and running efficiently.

Kit Contents

Your ARMOR 3 installation kit includes:

• ARMOR 3 Device
• 2-Wire Harness

Installation Steps

Locating Power Source:

• Identify a source of 12 volts continuous voltage and a ground for the installation. For this guide, we have chosen the vehicle's battery as the power source.

Device Installation:

• Please note that the ARMOR 3 device is not waterproof. However, it has been successfully installed in various vehicles without issues, including exposure to car washes.
• Before proceeding with the installation, take a photo of the ARMOR 3 device alongside the VIN sticker located inside the driver’s door. This will be important for device registration.
• Follow the instructions provided with your kit to connect the ARMOR 3 device to the 12-volt power source and ground using the 2-wire harness.

Testing Connectivity and Utilization:

• After installation, verify the device's connectivity and utilization by visiting https://check.armordata.io/home.
• Look for three checkmarks on the website, indicating:
  • Cellular connectivity.
  • Data reported in the last 4 hours.
  • Utilization reported in the last 4 hours.

Register the Device:

• Use the previously taken photo of the ARMOR 3 device and the vehicle's VIN sticker for registration.
• Email this photo to [email protected] to complete the registration process.

Conclusion

Thank you for choosing ARMOR 3 for your vehicle monitoring needs. Following these steps will ensure your device is installed correctly and fully operational. If you have any questions or require further assistance, please don't hesitate to reach out to our support team.

-- ARMOR Support