Introduction: Welcome to the ARMOR 4 with two-wire harness installation tutorial. Keith Bunch is here to guide you through the process, ensuring a smooth and effective setup.
Installation Steps:
Preparation:
- Unplug the batteries of the vehicle or machine to ensure safety during the installation.
Locating Power Source:
- Identify a power source within the vehicle or machine that provides 9 to 90 volts. This will be used to power the ARMOR 4 device.
Harness Installation:
- Install the ARMOR harness into the identified power source.
- Connect the ARMOR 4 device to the installed harness.
Device Activation:
- Once connected, verify that the lights on the ARMOR 4 device illuminate both red and green, indicating proper functioning.
Testing Device Functionality:
- Navigate to ARMOR Device Check and run your machine for 2 minutes.
- Enter your 15-digit IMEI in the provided field and click 'Check Device'.
- You should see three checks indicating successful connectivity, data reporting, and utilization.
Register the Device:
- Take a photo of the IMEI sticker alongside the machine's serial number tag.
- Email this photo to [email protected] and attach it to your work ticket for record-keeping.
Conclusion: Thank you for following this installation guide. Keith Bunch and everyone at ARMORdata.com appreciate your dedication to ensuring a correct setup. For further assistance or queries, feel free to contact our support team via our website ARMORdata.com.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article